How to Choose the Right JST Connector Type?
| Application | Recommended Series |
|---|---|
| FPV Drone/Flight Controller | GH (1.25mm) or SH(1.0mm) JST Series Connector |
| LiPo Battery (small) | PH(2.0mm) JST Series Connector |
| LiPo Battery (Large/RC) | XH(2.5mm) JST Series Connector |
| Arduino Sensor Wiring | PH(2.0mm) or Xh(2.5mm) JST Series Connector |
| 3D Printer Wiring | XH(2.5mm) or ZH(1.5mm) JST Series Connector |
| LED Strip Connection | SM(2.5mm) JST Series Connector |
| High Current/motor/Power | VH(3.96mm) JST Series Connector |
| Wearable/Ultra-Compact | SH(1.0mm) JST Series Connector |
Buying a JST connector isn’t just about pin count. Work through these six checks before you order:
- Check the pitch — measure your existing connector or check the manufacturer’s spec sheet. Don’t assume similar-looking connectors match.
- Check the pin count — 2-pin for simple power, 3-pin for power/ground/signal, 4-pin for multi-wire setups, and higher counts for complex connections.
- Check male/female compatibility — male housing + terminals, female housing + terminals, pre-crimped wire connectors, or PCB-mounted versions.
- Check wire size — match your crimp terminal to your wire gauge to avoid poor crimps and unreliable connections.
- Check orientation — straight, right-angle, top-entry, side-entry, PCB-mounted, or wire-to-wire, depending on your installation.
- Check voltage & current ratings — rated voltage, rated current, contact resistance, wire size, and operating temperature should all suit your application.


